L'Antre du Tryphon

This is an anti-vibration foot for the Prusa i3 MK3S. It should be printed with TPU for best results. You will need to print 4 of these! Support material is

This is a 5-1/4 inch round speaker enclosure. The total speaker depth is 50 mm. The screw holes for the speaker are 141 mm diagonally. You’ll need 4 x M3

This is a set of thickness gauges. The supplied thickness are 1, 2, 4, 8, 16 and 32 mm. Thicknesses from 1 up to 63 mm may be achieved by

This is a small caddy to hold up to 6 soldering iron tips, up to 3 spools of solder wire and a tip cleaner. The tip cleaner has a diameter

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also

This is a tray system to be installed on the stand of an ASUS VA32A monitor. You will need to print one small drawer and 2 large drawers. Two models

This is a simple white board shelf for the cleaning supplies. The first holder is 9.5 cm in diameter. The second holder is 6 cm in diameter. Two 5 mm

This is a modular Single Board Computers enclosure for up to 4 devices. The device cards are held vertically. This design let you service one card without having to remove

This simple white board organizer can hold 6 markers along with the eraser. This new design is thinner and have an opening at the bottom that lets you see the

This is a tray that holds up to 8 Wera micro screwdrivers. The design will hold the screwdriver labels upright. Multiple trays may be stacked. Support material is required for

I’ve tested 3 different Raspberry Pi used as firewalls at measured the performance I was getting. The Raspberry Pis are: Model 2B, rev 1.1 (a01041) with a BCM2835 processor, 1

This object is a simple micro SD card carrier having the same size as an SD card. It was designed to put a micro SD card into a SD card

My small personal photo album is back online. The main gallery of this photo album is Maquettes. It contains a few pictures of the models, my father, Paul-Émile Théroux built

This is a minimalist case for a Raspberry Pi 1B+, 2 or 3. Why another case when there are so many out there? This one has the smallest footprint. Most

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. Feet are also

This is a baseplate for the Waveshare Pi Pico Quad Expander. You will need 4 or more tiny screws to mount it. An infill of 15% is recommended. Support is

This is a coaster set. This design limits the contact surface between the recipient and the coaster. The deep design prevents the condensation waters from touching the recipient. Two storage

Two tools are now available in the GitHub repository located at https://github.com/ctheroux/LinuxUtilities-Users to create a program launcher for most Linux systems. The first version of them is a command-line version

This is a replacement of the stock Z Axis Cable Chain Holder of the TronXY X5SA. The straight design is inappropriate because of the nuts on the extrusion side. I

This is a stand when used with some DIN Rails makes a useful electronic prototyping rig. You will be able to move your prototypes easily with it. In the picture,