Coaster Set

 

This is a coaster set. This design limits the contact surface between the recipient and the coaster. The deep design prevents the condensation waters from touching the recipient.

Two storage rack are available: 4 and 6 coasters

They are 10 cm in diameter. They are 1 cm in height.

Support material is not needed. 0.1 mm layer height gives better results.

This object was designed using Solid Edge Community Edition.


Printable Files

  Coaster
  Rack for 4 coasters
  Rack for 6 coasters

This object is also published on the following site(s):
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2021 by Claude “Tryphon” Théroux

 

This is a coaster set. This design limits the contact surface between the recipient and the coaster. The deep design prevents the condensation waters from touching the recipient.

Two storage rack are available: 4 and 6 coasters

They are 10 cm in diameter. They are 1 cm in height.

Support material is not needed. 0.1 mm layer height gives better results.

This object was designed using Solid Edge Community Edition.


Printable Files

  Coaster
  Rack for 4 coasters
  Rack for 6 coasters

This object is also published on the following site(s):
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2021 by Claude “Tryphon” Théroux

Leave comment

Your email address will not be published. Comments are moderated before they are published. Required fields are marked with *.

Time limit is exhausted. Please reload the CAPTCHA.