L'Antre du Tryphon

This is a pen holder of an unusual design. Three sizes are available. You can increase the capacity of them by gluing another one on its side. Support is not

These simple steps will let you move a directory contained within a git repository into another one while preserving the history. Make the parent directory of the source git repository

This is a baseplate for the Waveshare Pi Pico Dual Expander. You will need 4 tiny screws to mount it. An infill of 15% is recommended. Support is not needed.

This is a simple stand for the 1802 (COSMAC ELF) Membership Card. The 1802 is a vintage micro-processor. You can get this kit at http://www.sunrise-ev.com/1802.htm . I’m not affiliated with

This is a tray designed to be installed on the stand of an LG 27EA33 monitor. You need to print the STL file provided and the same file mirrored. You

These are replacement pads for the Panavise 303 vise. It has groves to hold tubular objects. I’ve printed it in semi-flexible filament, but works fine printed in PLA. Support is

This is a modular SBC or Development Board enclosure. Its base design principle is you stack on top of each other plates that hold various devices such as Raspberry PI,

This is a box for a 3.5 inch hard drive and its cover. It was specifically designed to fit in a small safety box often rented by banks. Support is

This is an organizer especially designed for an electronic bench to hold small parts, screws, etc. Support is not needed. This object was designed using Solid Edge Community Edition. Printable

This is a magazine file 60 mm wide. It is designed for letter size paper. It is by design a bit smaller than the document it holds. It has holes

These are trays to put under a CR-10 3D printer. The separator of one tray are 15 mm in height. For the other one, 38 mm in height which is

  This is an open box that can be hanged using 2 screws. The diameter of the head of the screw must be less than 1 cm. Its dimensions are

  This is a small trashcan for 3D printing. The way the cover is designed, plastic stuff in the trashcan won’t spring back outside it. The trashcan is 80 mm

UPDATE: Ubuntu 20.10 fixes the issues listed below. ASUS came out recently with very powerful gaming laptops at a very good price. The hardware is quite recent. Installing Linux on

  It is a simple parametric round container. Open the ParametricBox.scad file with openScad ( http://www.openscad.org/ ) Modify the variables in Parameters.scad to suit your needs and save it. Open

  This object will let you suspend your wires and probes on a door. To complete this assembly, you will need a pipe or tube of 5/8 in or 16

  These are small drawer dividers. There are 2 models. One for the drawer cabinet sold by Canadian Tire. The other one is for drawer cabinet sold by Home Depot.

This is an anti-vibration foot for 40 mm aluminum extrusion. I had good results using semi-flexible filament. I added some anti-sliding pad. They were specifically designed for an Ender-3 printer.

  This is a stand for the Kotto Fume extractor that can be bought from Amazon. It raises the fume extractor by 3 cm. It can be printed without support.

  This is a spool holder designed for the Prusa MK3S or any Prusa i3 printers. The dimensions of the top of the main plate shoud be 6.25mm x 40mm.