40 MM T-Slot Adjustable Foot

A “40 mm T-Slot Adjustable Foot” is now available. More details at 40 mm T-Slot Adjustable Foot.

Read More

40 MM T-Slot Angle Bracket

A “40 mm T-Slot Angle Bracket” is now available. More details at 40 mm T-Slot Angle Bracket.

Read More

20 MM T-Slot End Caps

Some “20 mm T-Slot End Caps” are now available. More details at 20 MM T-Slot End Caps.

Read More

Lexar USB Stick Case

A “Lexar USB Stick Case” is now available. More details at Lexar USB Stick Case.

Read More

Simple, Yet Stylish Phone Stand Printable Rods

A “Simple, Yet Stylish Phone Stand Printable Rods” is now available. More details at Simple, yet stylish phone stand Printable Rods.

Read More

605ZZ Bearing Mockup

A “605ZZ Bearing Mockup” is now available. More details at 605ZZ Bearing Mockup.

Read More

40 Mm Fan Deflector

A “40 Mm Fan Deflector” is now available. More details at 40 mm Fan Deflector.

Read More

Power Outage Protection for 3D printers

A “Power Outage Protection for 3D printers” is now available. More details at Power Outage Protection for 3D printers.

Read More

Simple Spool Bushing V2

A Simple Spool Bushing is now available. More details at Simple Spool Bushing.

Read More

Print Bed Center Marker

A Print Bed Center Marker is now available. More details at Print Bed Center Marker.

Read More

Vertical Calibration Cylinder

A Vertical Calibration Cylinder is now available. More details at Vertical Calibration Cylinder.

Read More

Desk Organizer

A desk organizer is now available. More details at Desk Organizer.

Read More

Prusa i3 Bed Cable Guide

A Prusa i3 bed cable guide is now available. More details at Prusa i3 Bed Cable Guide.

Read More

Misan’s Another Compact Extruder Fan Holder

A fan holder is now available to complement Misan’s Another Compact Extruder. More details at Misan’s Another Compact Extruder Fan Holder.

Read More

Unclogging A 3D Print Head

Unclogging a 3D print head is not always an easy task, especially when you lack of the proper tools. They are sometimes hard to find. To unclog a .35mm J-Head

Read More

3D Printing Supply Estimator

A GCode Analyzer for 3D printing is now available. This on-line tool estimates the amount of filaments required and the cost to print a 3D object. Give the filament type,

Read More

Preventing warping when printing 3D ABS objects

The biggest issue when printing 3D ABS objects is warping. As an example, this 8 cm x 8 cm bit holder is badly warped. In this example, 5 mm. Adding

Read More

Cannot reach 110 Celsius with a Prusa PCB Heated Bed Mk 1

I was not able to reach 110 Celsius with a Prusa PCB Header Bed MK1. My initial installation was with the PCB traces down with a borosilicate glass on top

Read More

G-Code commands supported by Marlin

The G-Code commands supported by Marlin 3D printing firmware are: Implemented Codes G0 Rapid Motion G1 Coordinated Movement X Y Z E G2 CW ARC G3 CCW ARC G4 Dwell

Read More

Building a Prusa Mendel Iteration 2 3D Printer

It is not obvious to choose and get a 3D printer. There is quite a lot a choices on the market which can be divided in two categories: pre-assembled and

Read More