Chromatography Container

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename is the maximum length of the paper supported.

Support material is not required. An infill of 20% is recommended, 4 walls and 4 bottom layers.

This object was designed using Solid Edge Community Edition.


Printable Files

  Chromatography Container
  60 mm paper holder
  70 mm paper holder
  80 mm paper holder
  90 mm paper holder
  100 mm paper holder
  110 mm paper holder
  120 mm paper holder

This object is also published on the following site(s):
Prusa Printers
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2023 by Claude “Tryphon” Théroux

Leave comment

Your email address will not be published. Required fields are marked with *.

Time limit is exhausted. Please reload the CAPTCHA.