L'Antre du Tryphon

Triple 5mA battery trickle charger ——————————————————————————– This is a 5mA lead acid battery trickle charger along with its case. It works with any battery up to 35V. You can maintain

This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can

This is a parametric container with an overlapped lid. Support material is not required. An infill of 20% is recommended. This object was designed using openSCAD. Printable Files    Example

This is a small 8 ml inkwell design to be used to refill a fountain pen. Test it with water before putting ink in it. Printing parameters may prevent it

This is a parametric stamp handle. It works pretty well with silicon stamps. I’ve used superglue to attach the stamp to the handle. A sample STL file is provided. Use

This is a simple human interface project for Home Assistant. It helps me remind doing 2 daily tasks. Using Home Assistant automation, it lit a LED at a given time

This is a stand used to dry a Manna water bottle. Support material is not required. An infill of 30% is recommended. This object was designed using Solid Edge Community

This is a stand for managing to-do lists based on 1/8 of a letter size sheet of paper or 3″ x 5″ index cards. Templates are included for you to

This is a stand for managing to-do lists based on 1/8 of a letter size sheet of paper. A template is included for you to draw your to-do lists. It

This is a stand for managing to-do lists based on half 3″ x 5″ index cards. A template is included for you to draw your to-do lists. It can be

This is a parametric box generator with a cover flush with its body. Support material is not required. An infill of 20% is recommended. This object was designed using OpenSCAD.

This is a parametric bearing container generator. Some bearing definitions are supplied. It is easy to add some. Support material is not required. An infill of 20% is recommended. This

This is a parametric cylindrical objects container with lid generator. This object was primarily design to hold a set of round magnets. Support material is not required. An infill of

This is a cylindric container with a center pole generator. Support material is not required. An infill of 20% is recommended. This object was designed using OpenSCAD. Printable Files  

These are angled containers for the Ikea Ivar side units. Support is required. An infill of 20% is recommended. This object was designed using Solid Edge Community Edition. Printable Files

This is a parametric pen organizer. It is especially designed to organize fountain pens. The pens are laid down on card stock to prevent the plastic from scratching them. The

These are simple spice bottles rack. The bottles are 63 mm in diameter and 61 mm, in height. The rack is 3 bottles high and 2 or 3 bottles wide.

This is a variation of my pen holders that was published a while ago. This version is larger and has a shelf. The top part of it can hold index

This is a simple dust collector used when you drill a hole on a wall. It replaces my cardboard version of it. Support material is not required. An infill of

These are cases for the MKS PI and the TS-35 display running Klipper from MakerBase. These cases let you mount the MKS PI and the TS-35 separately on your 3D