L'Antre du Tryphon

These are two add-ons for the Desiccant Spool Tumbler designed by chuyskywalker (https://www.printables.com/model/436044-desiccant-spool-tumbler). I like the design. I’m constantly using them. A funnel is provided to fill them out with

This is a parametric funnel with optional hanging loop and angled stem. Support material is usually not required. An infill of 100% is recommended if used with liquids. This object

This is a device that holds cards that identify the filament loaded in the Bambu Lab AMS unit. The size of the cards are 42.3 mm x 76 mm which

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that has these form factors. The din rail clip can be attached temporarily to the

These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename

This is another Bambu Lab Magnetic Poop Container. It fits the P1P, P1S and the X1 series. Magnet up to 12 mm in diameter can be used. Their thickness can

This openSCAD script create feet for projects. It was designed for aluminum extrusion, but can be used for other purposes. The thickness of the sides will have an impact on

This is a parametric compartmented box with overlapped lib. The example is a box that contains electronic boards in small bags. Support material is not required. An infill of 20%

This post lists the spools compatible with the Bambu Lab AMS. I’ve used them. Compatibles : Not compatibles :

This is a parametric device holder for square devices. Options are provided for screw mounting holes. By adjusting the parameters will make it fit any square devices. Three practical examples

This is a simple tool that helps to remove the screen of a Bambu Lab P1P or P1S. Removing the screen after it was installed is a bit difficult. This

This post explains how to mount a BitLocker partition on a Linux system. You’ll need the BitLocker recovery key to do so, along with the device file (/dev/sd?) of the

This post explains how to mount a partition from a disk image file on a Linux system. Such a file may have been created using the dd command. The disk

This post give the main steps to achieve full data disk encryption. The disk password will be required during boot time. You will need the device name of the disk

You’ll find in this post the basic steps to create an encrypted luks file and open it. You’ll need to perform the following steps to create it: The following steps

Parametric Clickable Stamp Holder. It fit out of the box, the stamps distributed by Michaels’. The item numbers of these stamps are 10656553 and 10656558. Holder for 3 to 9

This is a holder for a Caliper and Folding Ruler for the Ikea Ivar. It is designed for the side units. The width of the folding ruler is 1.6 cm.

This is a parametric clickable stamps case. It fit out of the box the stamps distributed by Michaels’. The item numbers of these stamps are 10656553 and 10656558. Support material