L'Antre du Tryphon

This is a case for a XY-SK80H Buck Boost Converter. It fits many different models having this form factor (39mm x 71.3 mm). You’ll need the following to assemble it:

This is a cable holder for the Ikea Vattenkar organizer. A M3 x 6 mm nut and bolt or equivalent are required for assembly. Support material is not required. An

This is a bottle stabilizer parametric model. For now, it contains the configuration for Robert Oster and Noodle’s ink bottles. Support material is not required. An infill of 20% is

These are two add-ons for the Desiccant Spool Tumbler designed by chuyskywalker (https://www.printables.com/model/436044-desiccant-spool-tumbler). I like the design. I’m constantly using them. A funnel is provided to fill them out with

This is a parametric funnel with optional hanging loop and angled stem. Support material is usually not required. An infill of 100% is recommended if used with liquids. This object

This is a device that holds cards that identify the filament loaded in the Bambu Lab AMS unit. The size of the cards are 42.3 mm x 76 mm which

These are din rail mounts for an Arduino Uno and Mega 2560 or any board that has these form factors. The din rail clip can be attached temporarily to the

These are din rail breadboard mounts for 400 and 830 points breadboards. The din rail clips can be attached temporarily to the breadboard base using a piece of 1.75 mm

This is a small chromatography container. It can hold paper up to 5 cm in width, from 50 mm to 120 mm in length. The length given in the filename

This is another Bambu Lab Magnetic Poop Container. It fits the P1P, P1S and the X1 series. Magnet up to 12 mm in diameter can be used. Their thickness can

This openSCAD script create feet for projects. It was designed for aluminum extrusion, but can be used for other purposes. The thickness of the sides will have an impact on

This is a parametric compartmented box with overlapped lib. The example is a box that contains electronic boards in small bags. Support material is not required. An infill of 20%

This is a parametric device holder for square devices. Options are provided for screw mounting holes. By adjusting the parameters will make it fit any square devices. Three practical examples

This is a simple tool that helps to remove the screen of a Bambu Lab P1P or P1S. Removing the screen after it was installed is a bit difficult. This

Parametric Clickable Stamp Holder. It fit out of the box, the stamps distributed by Michaels’. The item numbers of these stamps are 10656553 and 10656558. Holder for 3 to 9

This is a holder for a Caliper and Folding Ruler for the Ikea Ivar. It is designed for the side units. The width of the folding ruler is 1.6 cm.

This is a parametric clickable stamps case. It fit out of the box the stamps distributed by Michaels’. The item numbers of these stamps are 10656553 and 10656558. Support material

Triple 5mA battery trickle charger ——————————————————————————– This is a 5mA lead acid battery trickle charger along with its case. It works with any battery up to 35V. You can maintain

This is another variation of the pen holder published previously. This one is the largest. It can hold about 64 pens. The top part of it is modular. It can

This is a parametric container with an overlapped lid. Support material is not required. An infill of 20% is recommended. This object was designed using openSCAD. Printable Files    Example