Parametric Hanging Box

This openSCAD model generates a box that can be attached using 2 screws on a wall, aluminum extrusion, etc. They can be offsetted from the center of the box if needed.

Support material is not required. An infill of 20% is recommended.

This object was designed using openSCAD.


Printable Files

  Parametric Hanging Box openSCAD file
  Small Hanging Box
  Large Hanging Box

This object is also published on the following site(s):
Prusa Printers
Thingiverse


The source files are available:

You may request the source file(s) of this object. Ask for it by posting a comment below. Your email address will NOT be used for any other purposes than delivering you the source files. By doing so:

You are free to:

* Share — copy and redistribute the material except the source files in any medium or format
* Adapt — remix, transform, and build upon the material

You agree to:

* give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
* not use the material for commercial purposes
* distribute your contributions under the same license as the original if you remix, transform, or build upon the material
* not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
* not upload the source files or modified source files on any sites. They are made available for your personal usage only. Nevertheless, you are allowed to upload the resulting STL or OBJ files.

If you do not agree to any of these conditions, do NOT request the source files.


Copyright 2012-2022 by Claude “Tryphon” Théroux

1 thought on “Parametric Hanging Box

Leave comment

Your email address will not be published. Required fields are marked with *.

Time limit is exhausted. Please reload the CAPTCHA.