L'Antre du Tryphon

  This is a paper tag holder made out of 4 inches (10.1 cm) x 3 inches (7.6 cm) index cards. They fit an edge of about 1/4 (6.25 mm)

  This kit of objects is two hanging buckets set for a cheap bench power supply. One bucket is 100 mm deep. The other is 50 mm deep. They are

  This object lets you install casters to a Bror workbench. It is designed for 1-7/8″ (48.5 mm) x 2-9/16″ (65.5 mm) casters. The holes for the bolts are 2-1/8″

  This is a 100 mm VESA mount designed to be mounted on the Ikea Ivar side units. As shown on the picture, I have used it to mount a

  This is a small pin design to hang stuff on the vertical post of Ikea Ivar side units. The pin is 3mm in diameter, 10 mm long. Support is

  This is a sleeve for Zip Ties. Its main utility is to protect the vertical supports of the Ikea Ivar system when using Zip Ties to attach stuff. They

  This is two battery tray design for the EN-EL10 batteries. They are used by Nikon for their point and shoot cameras. One of the design holds 6 batteries while

  This is a storage tray designed to hold 12 IN-12 Nixie Tubes. Each compartment is 30.5mm x 20.5mm x 20mm in height. It can be printed without support. This

  This is a simple holder for the set of 4 Picks and Hooks made by Stanley. It is designed for the north American pegboard. The holes are 1 inch

  It can hold up to 20 alligator clip cables. It is designed to be used with a North American pegboard. The distance between the holes is 1 inch (2.54

  This is a simple SCAD file that generates simple open boxes without chamfers or fillets. They fit snuggly together. A sample is included. To create a custom one: Open

  This is a simple Ivar Side Unit hook. No additional hardware is required. It can be printed without support. This object was designed using Fusion 360 Printable Files  

  This is a part cooling fan for the FlSun. The original design has only one fan that cools the extruder and the part at the same time but it

  These objects replace the poor stock nozzle cooling system provided by FLsun. You will need 2 x M3-20 mm bolts and nuts to mount the fan along with the

These are various cylindrical containers. Each container holds 10 bearings. For each size, two parts are required: the base and the lid. There are containers for the following bearings: 603ZZ,

  The stock Flsun Cube extruder is quite bad. I replaced it with an all-metal one available almost everywhere. The holder didn’t fit anymore. So I designed this one. Also

  Wire spools of various sizes. The main picture is the 60 x 40 mm wire spool. It holds about 20 meters (10 meters of 2 conductors wire) of 26

  These tool add-ons protect the cutting disks while being in storage and still mounted on their shaft. Two sizes are supplied: 28 mm and 36 mm. No additional hardware

  This is a simple voltmeter housing. These voltmeters are widely available on AliExpress or eBay. Their display size is typically 2.4cm x 1.4 cm (0.36 inch). The mounting holes

  This is a simple base plate for a popular Decade Box you can buy from China. The size of the Decade Box is 36mm x 90mm. You will need